This blog was originally started to better help me understand the technologies in the CCIE R&S blueprint; after completing the R&S track I have decided to transition the blog into a technology blog.

CCIE #29033

This blog will continue to include questions, troubleshooting scenarios, and references to existing and new technologies but will grow to include a variety of different platforms and technologies. Currently I have created over 185 questions/answers in regards to the CCIE R&S track!! Note: answers are in the comment field or within "Read More" section.

You can also follow me on twitter @FE80CC1E


Wednesday, June 29, 2011

CRS - Interface Naming

Interface Naming

r/s/m/p naming
rack/slot/module/port

show platform

RP/0/RP0/CPU0:router# show platform


Node                 Type                  PLIM                           State                  Config State
-------------------------------------------------------------------------------------------------------
0/0/SP                MSC(SP)         N/A                             IOS-XR RUN      PWR,NSHUT,MON
0/0/CPU0           MSC               16OC48-POS/DPT      IOS-XR RUN      PWR,NSHUT,MON
0/2/SP                MSC(SP)         N/A                             IOS-XR RUN      PWR,NSHUT,MON
0/2/CPU0           MSC               16OC48-POS/DPT      IOS-XR RUN      PWR,NSHUT,MON
0/RP0/CPU0      RP(Standby)    N/A                              IOS-XR RUN      PWR,NSHUT,MON
0/RP1/CPU0      RP(Active)       N/A                              IOS-XR RUN      PWR,NSHUT,MON
0/SM0/SP          FC/S(SP)         N/A                              IOS-XR RUN      PWR,NSHUT,MON

Note: 
FC=Fan Card
SM=Switch Module
AM=Alarm Module

Node
0/0/SP - Rack0, Slot0, Module Service Processor
0/0/CPU0 - Rack0, Slot0, CPU0 - Interfaces with the PLIM 16OC48-POS/DPT
0/RP0/CPU0  - Rack0, Route Processor, CPU0 

Type
Type of Card

PLIM
Idenifies Physical Layer Interface Module

State
shows the state of the node

Config State
PWR- Power
SHUT-Shut
MON-Monitor
NPWR- No Power
NSHUT-No Shut
UMON- Un Monitor


RP/0/RP0/CPU0:CRS-19(config)#show ipv4 interface brief

Interface                                     IP-Address      Status                Protocol
POS0/1/0/0                                    10.0.0.1        UP                    UP
TenGigE0/3/0/0                         unassigned      Shutdown              Down
TenGigE0/3/0/2                         unassigned      Shutdown              Down
MgmtEth0/RP0/CPU0/0            unassigned      Shutdown              Dow

Loopacks do not follow the r/s/m/p naming

POS0/1/0/0  - Rack0, Slot1, Module0, port 0
MgmtEth0/RP0/CPU0/0 - RP0, CPU0, Port0
TenGigE0/3/0/2 - Rack0, Slot3, Module0, Port2

0 comments:

Post a Comment